Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Coloured groups

Mechanical pulps are bleached by procedures that preserve lignin, but eliminate most coloured groups. Most mechanical pulps can be bleached to brightness levels of 75-80%, that are suitable for uncoated and coated papers. The principal bleaching procedures for mechanical pulps are reductive bleaching with sodium dithionite (hydrosulphite), and oxidative bleaching with peroxide under alkaline conditions. [Pg.492]

Finally, an exhaustive study of some of the variables affecting the measurement of tomato paste colour has been carried out as part of the COST 90 programme by Brimelow (1987). The effects of such factors as paste dilution, test duration, instrument aperture size and illumination area, sample temperature, standardisation hitching-post tile temperature, and the presence or absence of extraneous light were all examined. A standard colour measurement procedure was advocated for this important food commodity. As a parallel effort in this work, a new European standard tomato red tile was specified by the COST 90 colour group participants, to act as a hitching post in the measurement of tomato pastes and purees. [Pg.105]

In quantum chromodynamics, the colour group is SU(3), where the index is written to avoid confusion with the SU(3) group of flavour. In a baryon, the colour coupling of the three quarks to form a singlet, schematically... [Pg.19]

The most important reaction of the diazonium salts is the condensation with phenols or aromatic amines to form the intensely coloured azo compounds. The phenol or amine is called the secondary component, and the process of coupling with a diazonium salt is the basis of manufacture of all the azo dyestuffs. The entering azo group goes into the p-position of the benzene ring if this is free, otherwise it takes up the o-position, e.g. diazotized aniline coupled with phenol gives benzeneazophenol. When only half a molecular proportion of nitrous acid is used in the diazotization of an aromatic amine a diazo-amino compound is formed. [Pg.133]

Some nitro-compounds are themselves coloured and can be used as dyestuffs, e.g. picric acid. In this case the nitro-group can be considered to be the chromophore. For aliphatic nitro-compounds see nitroparaffins. [Pg.277]

Group III with electronic configuration 5s 4d . The principal ore is gadolinite (a silicate also containing lanthanides). Y2O3 containing Eu is used as a red phosphor in colour television. Yttrium iron garnets are used as microwave filters. [Pg.431]

All the cations of Group I produce a characteristic colour in a flame (lithium, red sodium, yellow potassium, violet rubidium, dark red caesium, blue). The test may be applied quantitatively by atomising an aqueous solution containing Group I cations into a flame and determining the intensities of emission over the visible spectrum with a spectrophotometer Jlame photometry). [Pg.136]

Calcium, strontium and barium produce characteristic flame colours like the Group 1 cations (calcium, orange strontium, red barium, green) and flame photometry can be used for their estimation. All give insoluble carbonates in neutral solution. [Pg.136]

Aminoazobenzene is a member of the large class of azo-compounds, all of which contain the characteristic grouping, C-N N-C. Azo-compounds are of considerable technical importance, as they are all coloured, and the majority possess considerable stability. They may be prepared by the following methods ... [Pg.209]

Dissolve ca. 0 2 g. of product (I) in cold ethanol, and add with shaking 1-2 drops of dilute sulphuric acid. A deep purple coloration appears at once. This shows that salt formation has occurred on the quinoline nitrogen atom to form the cation (Ha), which will form a resonance hybrid with the quinonoid form tils). [Note that the forms (IIa) and (11b) differ only in electron position, and they are not therefore tautomeric.] If, hoAvever, salt formation had occurred on the dimethylaniino group to give the cation (III), thrs charge separiition could not occur, and the deep colour would be absent. [Pg.303]

This is a test for the >C = 0 group. Most aldehydes and ketones readily condense with this reagent giving yello v- or orange-coloured precipitates. [Pg.334]

Aliphatic ketones containing the CH3CO— group restore the colour very slowly to SchifTs reagent other ketones have no reaction. [Pg.345]

Nitro compounds, when hquid, have characteristic odours, are insoluble in water, highly refractive and with a density greater than unity. Many are crystalline sohds. Most nitro compounds are slightly coloured, generally yellow the intensity of the colour increases with the number of nitro groups. The following reactions will assist in their detection. [Pg.528]

The azo dyes are not of any great practical value owing to their slight solubility in water. Th4 introduction of a sulphonic acid group into the molecide has no effect upon the colour, but renders the dye water-soluble—a fact of great commercial value. The simplest way of achieving this is to employ an amine, e.g., sulphanilic acid, in which the — OjH group is already present. [Pg.620]


See other pages where Coloured groups is mentioned: [Pg.3]    [Pg.275]    [Pg.86]    [Pg.1182]    [Pg.3]    [Pg.275]    [Pg.86]    [Pg.1182]    [Pg.34]    [Pg.35]    [Pg.49]    [Pg.60]    [Pg.61]    [Pg.99]    [Pg.174]    [Pg.206]    [Pg.215]    [Pg.231]    [Pg.239]    [Pg.261]    [Pg.275]    [Pg.319]    [Pg.338]    [Pg.386]    [Pg.395]    [Pg.398]    [Pg.411]    [Pg.413]    [Pg.13]    [Pg.59]    [Pg.60]    [Pg.416]    [Pg.501]    [Pg.506]    [Pg.657]    [Pg.703]    [Pg.178]    [Pg.528]    [Pg.680]    [Pg.748]   
See also in sourсe #XX -- [ Pg.3 ]




SEARCH



Colour point groups

Colour-forming groups

Magnetic point groups and colour symmetry

© 2026 chempedia.info